This one doesn't make much sense (since when are micros too big?), but it's cute..
65 thoughts on “ FPV Micro Quadcopter Build V2 – Beef Brushed Board – 8.5mm Motor ” Christophe BOUDIAS 14th October 2018 at 11:19 pm. Hello dear I have a micro camera FPV I will put it on my Hubsan H107D. I have a technical question: the camera comes with 4 wires ( red,black, yellow and white). Jan 09, 2016 I immediately tried again, reviewing my settings, but the board will no longer connect to anything and will no longer even go through its boot sequence. I read that the Naze boards have a bootloader short option, but I don't see anything like that labeled on this board. I found an old user manual that did lable two open pins as 'boot'.
Here's the super-tiny FrSky-compatible receiver from Curtis 'Beef' Fissel (of Beef's Brushed Board fame). This photo shows the receiver after I soldered on a three-pin header, solder-bridged the bind pads, connected it to the Flip32, powered the Flip32 through the USB port bound the receiver to my Taranis, and un-soldered the bridge.
![]()
83x58mm when folded, 138mm motor-to-motor (diagonally) when unfolded. So no, its not very micro, I know. And it's one heavy micro, don't expect to do any acro with it. I designed it mostly because I had an idea and I like to draw stuff ;)
![]()
The Quanum micro camera/vtx combo from HobbyKing fits perfectly and the camera angle is adjustable between 0 and 30 degrees. The arms have slots for clean wiring and to prevent accidental cutting of motor wires when folding the arms.
I'm running mine with the following hardware:
If you use a Beef's Brushed Board you'll also need an FTDI adapter to communicate with the board
http://www.ebay.com/sch/i.html?_from=R40&_trksid=p2050601.m570.l1313.TR0.TRC0.H0.Xusb+ftdi.TRS0&_nkw=usb+ftdi&_sacat=0
I used the setup above mainly because I already had all the necessary parts at home, there are (most likely) better/cheaper parts out there if you google. There are also a bunch of links in the comments to alternate hardware
Here's a good page to get you started with hardware similar to the one listed above
https://oscarliang.com/fpv-micro-quad-beef-board/
Iphone 5s ios 11 issues. UPDATE 160709:
Added new arms with slits for the motors (as shown in the pictures). Uploaded the wrong version previously, sorry Beef's Brushed Board User Manual Free
UPDATE 160716:
Added new, thicker arms for you guys who prints in PLA. These should hold up better in a crash. Also, user unclecracker made a remix of the arms to fit 7mm motors: http://www.thingiverse.com/thing:1675767 Beef's Brushed Board Manual
UPDATE 170209
Here's a nice camera mount for the Eachine TX03 (and probably other AiOs as well) by murrayp0473 http://www.thingiverse. https://heavenlycourse610.weebly.com/moulinex-masterchef-650-duotronic-user-manual.html. com/thing:2094946 User manual for whirlpool microwave model mh7140xfbo. Comments are closed.
|
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2020
Categories |